WireMate Installation
WireMate is a simple to install product that requires no other tools that a screwdriver, which is optional for permanent fixture. Follow the simple instructions below to install your WireMate.
- Turn off power supply
- Remove the WireMate cover by firmly pressing tips or middle of the two locking tabs at each end, while separating the cover from the base.
- Affix the double sided peel off tape to the four corners of the base. The tape works very well with all applications, screws also provided
- Position base where wire excess will cause tangling. It can be positioned vertically, horizontally, inverted or remain free standing
- Run wires through the WireMate integrated posts as the set-up illustration shows. Leave about ¼ " slack in each wire at the entry point for the first loop only to minimize force placed on the base. The remaining loops should be snug. For existing setups, disconnect any knotted wires at one end only, to unknot and reconnect after WireMated.
- Press and snap cover on the base.
- Turn on power supply.
